mq snorkles

[muduppig]

:D does anyone happento have a template type thing lying around to do a snorkle on sd33 mq plus i had to post something the mg/mk forum was being left behind

[Screwy]

ive got a safari snorkel on mine, but they would be sooo easy to make its not funny.
Use a 2.5 inch hole saw and drill a hole in the quarter panel and inner quarter panel so it comes out in the engine bay right between the RHS of the passenger side quarter panel and stick a piece of straight pipe through the hole with some flexy rubber pipe inbetween the pipe and the Pre filter.
Then cut a 45 degrees cut in the pipe and the to that to a new peice and weld it together in right angles so it runs up the A piller and cut it flat at the top and put a snorkel head no it :D

Shuold take about 2 hours max if you have all the bits 8)

[muduppig]

thanks for that i will start get bits together

[Big Red Toy]

90mm pvc pipe :victory:

[Big Red Toy]

90mm pvc pipe :victory:
Total cost $15