Patrol 4x4 - Nissan Patrol Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Auto Electrical
    I installed a mac vacuum solenoid to replace the factory version. It works fine in the off position but it will not switch to the on position. The reason for this is that the power does switch tot the bottom port but there is still 3 volts on the top port. If I disconnect the top port all is...
  2. Auto Electrical
    Gents Im putting in a dual battery system in my 2013 GU . looking for the nicest place to mount solenoid is quite the cunundrem . mounting solenoid closest to main battery their isn't much room and should it be mounted as close to main as possible ? im looking at putting in the intervolt DCDC...
  3. Nissan Patrol GU/GR Y61
    have just installed a MAC Solenoid (part no. 45A-GC1-DDBA-1BA) with no luck, the diff lock still does not engage? am I missing something here, it's been mentioned maybe the solenoid itself is not receiving enough voltage to operate? I have not come across any info regarding this. I'm...
  4. Auto Electrical
    Hi Guys, Im going to get a winch hopefully at this weekends Perth 4wd show. I've done some research and would like to isolate the winch. I would like to isolate one of the control wires rather than the main RED Positive wire as the amp draw can get upto 400amps. It'll be easier to isolate a...
  5. Nissan Patrol GQ/Y60 & Ford Maverick
    hi guys, starter motor is in its way out, want to get some recommendations on a replacement. my mate says to take it to an auto elec and get a reconditioned one put in. repco quoted $340. eBay prices start at $220. and I've never done one before, but am pretty good working around the car, so...
1-5 of 5 Results
Top