Patrol 4x4 - Nissan Patrol Forum banner
1 - 3 of 3 Posts

·
Registered
nissan patrol 2010
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello all,
I have a 2010 zd30ddti common rail.
I am trying to read a fault code using the 'bridge terminals 1 and 8' method on the diagnostic connector.
My connector has no conductor to terminal 1 !? Wires go to 4,5,6,7,8,14 and 16 only, see image attached.
Does anyone definitely know which ones to bridge ?? I really do not want to bugger the PCM
by bridging the wrong ones.
Thanks in anticipation.
 

Attachments

·
Registered
Nissan Gu Y61 patrol
Joined
·
3 Posts
Hello all,
I have a 2010 zd30ddti common rail.
I am trying to read a fault code using the 'bridge terminals 1 and 8' method on the diagnostic connector.
My connector has no conductor to terminal 1 !? Wires go to 4,5,6,7,8,14 and 16 only, see image attached.
Does anyone definitely know which ones to bridge ?? I really do not want to bugger the PCM
by bridging the wrong ones.
Thanks in anticipation.
Hey sorry to bring up an old thread but did resolve this or work out where the missing pin is?
2011 crd wagon has same pin layout as you.
Wanting to manually flash engine codes.
Cheers
 
1 - 3 of 3 Posts
Top