Patrol 4x4 - Nissan Patrol Forum banner

1 - 1 of 1 Posts

·
Registered
nissan patrol gq
Joined
·
3 Posts
Discussion Starter #1
I recently fitted a tekonsha 2030 mark 12 brake control unit to my GQ Nissan Patrol and I don't think it is working properly. When I disconect the brake magnets and I apply the brakes I am getting 11.8 volts at the hubs. When I refit the magnets and I apply the brakes the voltage drops to 7.5 volts. I have run 4mm wire through and but have only crimped the joints which I intend to solder. Could this cause my woes or could it maybe the brake control unit. Any help or advice is greatly appreciated. Regards Ken
 
1 - 1 of 1 Posts
Top