Hi all
I am going to put a uhf in a new 2011 GU IV and want to know the best route for the coax from the aerial on the BB to the cab. The firewall is locked up tight and the main wiring loom is heat shrink wrapped, folded double before entering a very full looking grommet.
I would not like to make any new holes in the firewall seals and am considering opening up the main loom adding the coax and about 5 extra electrical wire as spares for future projects and then sealing it up again and re-installing. Not sure if heat shrink tape is available as the tube type wont work?
Also read some issues with kinking coax so not sure about folding the loom wiring double when re-installed.
Any suggestions welcome.
thanks
I am going to put a uhf in a new 2011 GU IV and want to know the best route for the coax from the aerial on the BB to the cab. The firewall is locked up tight and the main wiring loom is heat shrink wrapped, folded double before entering a very full looking grommet.
I would not like to make any new holes in the firewall seals and am considering opening up the main loom adding the coax and about 5 extra electrical wire as spares for future projects and then sealing it up again and re-installing. Not sure if heat shrink tape is available as the tube type wont work?
Also read some issues with kinking coax so not sure about folding the loom wiring double when re-installed.
Any suggestions welcome.
thanks
