Patrol 4x4 - Nissan Patrol Forum banner
1 - 3 of 3 Posts

·
Registered
nissan
Joined
·
172 Posts
Discussion Starter · #1 ·
Hi All

I am about to start a GU 2.8 to TD42Ti conversion. Engine is out of an 06 model patrol. I have a gearbox out of a ZD30 and will require a bell housing. When the engine arrived there was supposed to be a bell housing with it but was not there. The wreckers are sending me one from a GQ TD42. Will this fit the GUTD42Ti or are they different.

Thanks
 

·
Registered
nissan
Joined
·
11,202 Posts
i cant see any difference to be honest. td42 and td42t use the same block basically so same bolt pattern. long as it fits on the 3l gearbox, which again pretty sure they are the same. all will be swell.
 

·
Registered
nissan
Joined
·
172 Posts
Discussion Starter · #3 ·
Thanks for that. It will fit the 3l box. I had it in my mind that it would fit the motor as well but when I spoke to a wreckers here in Melbourne I got off the phone with doubts in my mind.He started talking flywheels and sandwich plates and at the end of it I was pretty confused. Will know next week when GQ housing arrives.
 
1 - 3 of 3 Posts
Top