[ar3nbe]

Just a quick one for those who have mounted lights ontop of their bullbar.

What mounting system did you use/where did you buy it from ?

 

[the evil twin]

Oh Oh can I be first... "you know it's illegal don't you?"

ROFL, sorry couldn't resist...

Most people use the antenna mounts already welded to the bar or weld similar tabs on. A mate ran a right angle section between the two tabs and drilled holes in that

PIA IMHO as it makes the engine bay all but inaccesible... but... Pffft whatever gives you a doughy

 

[adricat]

GME MB024ss - Antenna Mounts & Leads products and equipment | RB Communications

http://www.ryda.com.au/UHF-Mounting-Hardware-s/700.htm

Or similar

 

[89 GQ]

Just get 2 bits of plate say 4mm drill a hole in it, weld it to bullbar. Put light in it. Simple

 

[skegbudley]

Since this is in general chat instead of technical.
Use occy straps. Works fine for dolfin torches on MX bikes.

 

[waz65]

Since this is in general chat instead of technical.
Use occy straps. Works fine for dolfin torches on MX bikes.

100 MPH tape if the occy straps fail

 

[skegbudley]

Come to think about it. I had my winch controller attached to the bullbar with occy straps for 6 months.

 

[DB-101]

What's this post doing here, this is where we slag off pollies, set the world straight and run down all the refugees.

 

[Traitor]

I have a unhealthy affliction with Occy Straps really should see a doctor about it....

 

[the evil twin]

It is politically incorrect to call them Occy Straps if there aren't 8 of them... can the thread stay here now?