Patrol 4x4 - Nissan Patrol Forum banner
1 - 2 of 2 Posts

· Registered
132 Posts
Discussion Starter · #1 ·
Im currently making a new rear bar with intergrated spare wheel carrier, and high lift jack carrier, it will probably be sorta part of my tow bar as well.
During winter i mashed my drivers side guard pretty bad dropping into a deep rut, so i want to chop it and make the rear bar wrap around. The rear bar will be mainly 2x 50mm tube and im going to have some high lift jack points on it somewhere.

So just trying to find out who has done a rear 1/4 guard chop and how to go about it the best way and where to cut it so it doesnt look crap, I can get hold of a mig pretty easy to weld it back up.

Also is there any legalitys with doing this???

If anyone has any pics that would be nice :)

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.