Patrol 4x4 - Nissan Patrol Forum banner
1 - 4 of 4 Posts

· Registered
52 Posts
Discussion Starter · #1 ·
I have owned a 89 GQ SWB 4.2 auto since new. I also have sitting in front of me a Pertronix 1762LS ignitor which I am about to fit to the beast using the original coil. I know the black wire from the Pertronix goes to the negative side of the coil, but I have searched on this forum and been given 2 different answers as to where to connect the red wire from the Pertronix. So my question is; does the red wire from the Pertronix go to the connection with the red wires on the ballast-resistor or to the connection with the black&white wire and why?
With the engine NOT running and ignition switch on, I have 12.35v at the battery, 5.52v at the red wire connection on the resistor and 10.93v at the black wire connection on the resistor. I dont want to stuff it

Thanks in advance.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.