[Rat Dat]

Hi... Does anyone know if I can get a replacement ball joint for the rear sway disconect link pin? Mine needs to be replaced for RWC and it's totally shagged
Nissan wanted $1500 for a whole new unit lol.
Also, are they even ae to be removed from the link pin coz having no luck their either.

 

[Bogger]

Was pretty sure road runner or the like sell a plate that can be used to get rid of the disconnect all together and just run standard links.

Found it, here is a link:

http://www.roadrunneroffroad.com.au/Nissan-GQ-GU-Patrol--Sway-Bar-Blanking-Plate.html

 

[Rat Dat]

Other pic

 

[Rat Dat]

Cheers bogger, something I will consider for sure

 

[aussie_stu]

hey mate, if you haven't fixed this already, if you heat up the socket it'll unscrew from the disconnect shaft, then take it to a bearing joint and you should be able to get a replacement ball joint or you could swap it out for a rose joint, the thread will be M10x1.25

 

[sudso]

Cheers bogger, something I will consider for sure

I've replacement ball joints for them as I make extensions for the disconnects for lifted rigs. The original joints can be unscrewed but they are extremely hard to get off.

 

[sim79]

hey mate, if you haven't fixed this already, if you heat up the socket it'll unscrew from the disconnect shaft, then take it to a bearing joint and you should be able to get a replacement ball joint or you could swap it out for a rose joint, the thread will be M10x1.25

X2 a bearing shop , I replaced mine with a heim joint for $15