Recovery Plates

1 - 1 of 1 Posts

Pep

Registered

Joined Jul 6, 2009

284 Posts

Discussion Starter • #1 • Oct 31, 2010

Hi All

Does anyone have a drawing or a scan that i could use to draw my own, of these plates

http://www.bbmmotorsports.com.au/thumbnaillarge/wsOBNIS.jpg

Cause at $75ea i can get my own lasercut.

Thanks Pep

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

What did you do to your GU/GQ Patrol today?

General Patrol Discussion

So as the title says, what did you do to your patrol today, fitted a 6" lift or just swapped some tyres over? Ill start, today i removed about 50m of unused wiring that was in the car when i got it and the 5 relays that done NOTHING! and 2 switches on the dash that went no where. Then i put a...
- 15K
- 1M
- yumpet · updated 3 d ago
Rear Bar Tyre Carrie for a 37 inch tyre.

General Patrol Discussion

Hey All, In my never-ending quest to run 37's on the old girl (2011 Gu wagon). I have hit a roadblock. Does anyone know of a supplier or manufacturer of a rear bar that can hold a 37-inch tire. I have searched the net and only find the Jeeps that can hold 37's. Any help ... please. Thanks...
- 2
- 128
- M
  michaeljfhowse · updated 6 d ago
TD42 hand crank torque?

General Patrol Discussion

Hi Guys, I am about finishing my TD42 (GQ or GU, they are the same) rebuild. Before I fit it in the car, I am hand cranking it to make sure that nothing is seized as I had one of the rod resized and brandnew rod bearings). I found it very hard to crank even without head on, the torque is...
- 19
- 504
- neixian · updated 7 d ago
Remote reservoir for td42

General Patrol Discussion

Just wanting to know which model crd , as has the power steering reservoir and bracket has it mounted next to the battery as i have a plenum facing forward for a fmic Thanks Jono
- 11
- 746
- Jjjag2099 · updated 8 d ago
Mechanic in Sydney for Lokka install and front end maintenance?

General Patrol Discussion

Just ordered a front lokka from 4wdsystems. Having done my research, I reckon it's a winner for the price and simplicity. While I'd like to learn, I'm not really up to the task of installation myself and don't have the time. I figure it's a good time to have the front end refreshed anyway...
- 0
- 61
- J
  jackbyo · updated 8 d ago