I had a worn spot on my drivers seat from jumping in and out. I looked at getting canvas seat covers to stop it getting any worse, but I couldnt get any to fit (ST-L) I spoke to a couple of motor trimmers and found it was going to be too expensive to recover. What I ended up doing was getting the two front seat bases swapped over, the foam replaced on the worn side, and the cover tightened up. Cost me $100 and looks great. All the other options were just way too expensive.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.